Cisco ONS 15454 Series Procedure Manual page 250

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

NTP-A304 Provision CE-100T-8 Ethernet Ports
Click the Provisioning > Port tabs.
Step 4
Verify the following settings:
Step 5
Step 6
Repeat Steps
At the destination node, connect the Ethernet test to the destination port and configure the test set to send
Step 7
and receive the appropriate Ethernet traffic.
Note
At the source node, connect an Ethernet test set to the source port and configure the test set to send and
Step 8
receive the appropriate Ethernet traffic.
Transmit Ethernet frames between both test sets. If you cannot transmit and receive Ethernet traffic
Step 9
between the nodes, repeat Steps
correctly.
Perform protection switch testing appropriate to the SONET topology:
Step 10
Configure your test set according to local site practice. For information about configuring your test set,
see your test set user guide.
Complete the
Step 11
circuit ports to the IS-NR service state.
After the circuit test is complete, print the results or save them to a disk for future reference. For
Step 12
information about printing or saving test results, see your test set user guide.
Stop. You have completed this procedure.
NTP-A304 Provision CE-100T-8 Ethernet Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 Procedure Guide, R5.0
6-82
State—OOS,MT
Flow Control Neg—Checked or unchecked as indicated by the circuit or site plan
Max Size—Select between Jumbo and 1548 as indicated by the circuit or site plan
Media Type— SX, LX, ZX, CWDM, or DWDM
1
through
5
for the destination node.
At this point, you are not able to send and receive Ethernet traffic.
For path protection configurations, complete the
page
17-95.
For BLSRs, complete the
"DLP-A230 Change a Circuit Service State" task on page 19-19
This task provisions CE-100T-8 Ethernet ports to carry traffic.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
1
through
8
to make sure you configured the Ethernet ports and test set
"DLP-A94 Path Protection Switching Test" task on
"DLP-A91 BLSR Switch Test" task on page
Chapter 6
Create Circuits and VT Tunnels
17-87.
to change the circuit and
August 2005

Advertisement

Table of Contents
loading

Table of Contents