Figure - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

NTP-A38 Provision a Linear ADM Network
Verify that the test set has a clean signal. If a clean signal is not present, repeat Steps
Step 11
make sure the test set and cabling are configured correctly.
If a node fails any test, repeat the test while verifying correct setup and configuration. If the test fails
Step 12
again, refer to the next level of support.
Inject BIT errors from the test set. Verify that the errors appear at the test set, indicating a complete
Step 13
end-to-end circuit.
Complete the
Step 14
Complete the
Step 15
Complete the
Step 16
Set up and complete a bit error rate (BER) test. Use the existing configuration and follow your site
Step 17
requirements for the specified length of time. Record the test results and configuration.
Remove any loopbacks, switches, or test sets from the nodes after all testing is complete.
Step 18
From the View menu, choose Go to Network View.
Step 19
Click the Alarms tab.
Step 20
a.
b.
c.
Step 21
Repeat Steps
If a node fails any test, repeat the test while verifying correct setup and configuration. If the test fails
Step 22
again, refer to the next level of support.
Step 23
Delete the test circuit. See the
After all tests are successfully completed and no alarms exist in the network, the network is ready for
service application.
Stop. You have completed this procedure.
NTP-A38 Provision a Linear ADM Network
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
provision in a linear ADM network. If you are already logged in, continue with Step 2.
Cisco ONS 15454 Procedure Guide, R5.0
5-6
"DLP-A356 TCC2/TCC2P Card Active/Standby Switch Test" task on page
"DLP-A255 Cross-Connect Card Side Switch Test" task on page
"DLP-A88 Optical 1+1 Protection Test" task on page
Verify that the alarm filter is not on. See the
page 19-17
as necessary.
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
Complete the
"DLP-A516 Export CTC Data" task on page 22-6
9
through
20
for the other point-to-point node.
This procedure provisions three or more ONS 15454s in a linear add-drop
multiplexer (ADM) configuration.
None
NTP-A35 Verify Node Turn-Up, page 5-2
As needed
Onsite
Provisioning and higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A227 Disable Alarm Filtering" task on
"DLP-A333 Delete Circuits" task on page
Chapter 5
6
19-37.
17-85.
to export the alarms information.
20-21.
at an ONS 15454 where you want to
Turn Up Network
through
10
to
20-40.
December 2004

Advertisement

Table of Contents
loading

Table of Contents