Dlp- A470 Remove Gbic Or Sfp Connectors - Cisco ONS 15454 Series Procedure Manual

DLP-A470 Remove GBIC or SFP Connectors
c.
d.
For GBICs with a handle:
Step 5
a.
b.
c.
d.
e.
Class 1 laser product. Statement 1008
Warning
Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Warning
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of
100 mm could pose an eye hazard. Statement 1056
For SFPs:
Step 6
a.
b.
c.
Return to your originating procedure (NTP).
Step 7
DLP-A470 Remove GBIC or SFP Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Warning
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of
100 mm could pose an eye hazard. Statement 1056
Cisco ONS 15454 Procedure Guide, R5.0
21-26
When you are ready to attach the network fiber-optic cable, remove the protective plug from the
GBIC and save the plug for future use.
Continue with Step 7.
Remove the protective plug from the SC-type connector.
Grip the sides of the GBIC with your thumb and forefinger and insert the GBIC into the slot on the
card.
Lock the GBIC into place by closing the handle down. The handle is in the correct closed position
when it does not obstruct access to an SC-type connector.
Slide the GBIC through the cover flap until you hear a click.
The click indicates that the GBIC is locked into the slot.
Continue with Step 7.
Plug the LC duplex connector of the fiber into a Cisco-supported SFP connector.
If the new SFP connector has a latch, close the latch over the cable to secure it.
Plug the cabled SFP connector into the card port until it clicks.
This task disconnects fiber attached to GBICs or SFPs and removes the
GBICs or SFPs.
None
DLP-A469 Install GBIC or SFP Connectors, page 21-24
As needed
Onsite
None
Chapter 21 DLPs A400 to A499
March 2005