Dlp- A524 Download An Alarm Severity Profile - Cisco ONS 15454 Series Procedure Manual

DLP-A524 Download an Alarm Severity Profile
b.
c.
Suppressed alarms will reappear in the Alarms window. (They might have previously been cleared from
the window using the Synchronize button.) The AS-CMD alarm with the port object (for example,
FAC-16-1) will be cleared in all views.
Return to your originating procedure (NTP).
Step 4
DLP-A524 Download an Alarm Severity Profile
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To access the alarm profile editor:
Step 1
•
•
•
•
Click Load.
Step 2
If you want to download a profile that exists on the node, click From Node in the Load Profile(s)
Step 3
dialog box.
a.
b.
Cisco ONS 15454 Procedure Guide, R5.0
22-20
If the card is an FC_MR-4, E-Series Ethernet, G-Series Ethernet, OC-N, or electrical (DS-1,
•
DS-1N, DS-3, DS-3E, DS3i, DS3i-N, DS-3N, DS-3NE, DS3XM, or EC-1) card, click the
Provisioning > Alarm Profiles > Alarm Behavior tabs.
If the card is an ML-Series Ethernet (traffic) card, click the Provisioning > Ether Alarming >
•
Alarm Behavior tabs to apply the profile to the front physical ports, or the Provisioning >
POS Alarming > Alarm Behavior tabs to apply the profile to the POS ports. For more
information about ML-Series card ports and service, see the Ethernet Card Software Feature
and Configuration Guide for the Cisco ONS 15454 SDH, Cisco ONS 15454, and
Cisco ONS 15327.
Uncheck the Suppress Alarms check box for the port(s) you no longer want to suppress.
Click Apply.
This task downloads a custom alarm severity profile from a
network-drive-accessible CD-ROM, floppy disk, or hard disk location.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
From network view, click the Provisioning > Alarm Profiles tabs.
From node view, click the Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
From the card view of an FC_MR-4, E-Series Ethernet, G-Series Ethernet, OC-N, or electrical
(DS-1, DS-1N, DS-3, DS-3E, DS3i, DS3i-N, DS-3N, DS-3NE, DS3XM, or EC-1) card, click the
Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
From the card view of an ML-Series Ethernet (traffic) card, click the Provisioning > Ether
Alarming > Alarm Behavior tabs to apply the profile to the front physical ports, or the
Provisioning > POS Alarming > Alarm Behavior tabs to apply the profile to the POS ports. For
more information about ML-Series card ports and service, see the Ethernet Card Software Feature
and Configuration Guide for the Cisco ONS 15454 SDH, Cisco ONS 15454, and Cisco ONS 15327.
Click the node name you are logged into in the Node Names list.
Click the name of the profile in the Profile Names list, such as Default.
Chapter 22 DLPs A500 to A599
October 2005