Ntp- A145 Create An E-Series Multicard Etherswitch Manual Cross-Connect - Cisco ONS 15454 Series Procedure Manual

NTP-A145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect
State—The circuit is in service (default).
•
Apply to drop ports—Uncheck this box.
•
Protected Drops—Leave the default unchanged (unchecked).
•
If the circuit will be routed on a path protection, complete the
Step 10
Selectors" task on page
Click Next.
Step 11
Provision the cross-connect source:
Step 12
a. From the Node drop-down list, choose the cross-connect source node.
b. From the Slot drop-down list, choose Ethergroup.
Click Next.
Step 13
From the Node drop-down list in the Destination area, choose the circuit source node selected in
Step 14
For Ethernet cross-connects, the source and destination nodes are the same.
The Slot field is provisioned automatically for Ethergroup.
Click Next.
Step 15
Review the VLANs listed in the Available VLANs list. If the VLAN you want to use appears, continue
Step 16
with Step
Click the New VLAN button.
a.
In the Define New VLAN dialog box, complete the following:
b.
•
•
•
Click OK.
c.
Tip
In the Available VLANs column, click the VLAN you want to use and click the arrow button (>>) to
Step 17
move the VLAN to the Circuit VLANs column.
Click Next.
Step 18
In the left pane of the Circuit Routing Preferences panel, confirm that the following information is
Step 19
correct:
Circuit name
•
Circuit type
•
• Circuit size
• VLANs
ONS nodes
•
If the information is not correct, click the Back button and repeat Steps
Step 20
information. If the information is correct, check Route Automatically.
Click Finish.
Step 21
Cisco ONS 15454 Procedure Guide, R5.0
6-70
19-12.
18. If you need to create a new VLAN, complete the following steps:
VLAN Name—Assign an easily identifiable name to your VLAN.
VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15454 network supports
a maximum of 509 user-provisionable VLANs.
Topology Host—Choose the topology host ID from the drop-down list.
You can also add VLANs in network view by choosing Tools > Manage VLANs. In the All
VLANs dialog box, click the Create button to open the Define New VLAN dialog box.
Chapter 6 Create Circuits and VT Tunnels
"DLP-A218 Provision Path Protection
7 through 19 with the correct
Step 12.
August 2005