Dlp- A232 Change Active And Standby Span Color - Cisco ONS 15454 Series Procedure Manual

Chapter 19 DLPs A200 to A299
DLP-A232 Change Active and Standby Span Color
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Edit menu in any view, choose Preferences.
Step 1
In the Preferences dialog box, click the Circuit tab.
Step 2
Step 3 Complete one or more of the following steps, as required:
•
•
•
As needed, change the color of the active span:
Step 4
a.
b.
c.
As needed, change the color of the standby span:
Step 5
a.
b.
c.
As needed, return the active and standby spans to their default colors:
Step 6
a.
b.
c.
d.
Return to your originating procedure (NTP).
Step 7
September 2005
This task changes the color of active (working) and standby (protect)
circuit spans shown on the detailed circuit map of the Edit Circuits
window. By default, working spans are green and protect spans are purple.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
To change the color of the active (working) span, go to
To change the color of the standby (protect) span, go to
To return active and standby spans to their default colors, go to
In the Span Colors area, click the colored square near the word Active.
In the Pick a Color dialog box, click the color for the active span, or click the Reset button if you
want the active span to display the last applied (saved) color.
Click OK to close the Pick a Color dialog box. If you want to change the standby span color, go to
Step 5. If not, click OK to save the change and close the Preferences dialog box, or click Apply to
save the change and keep the Preferences dialog box open.
In the Span Colors area, click the colored square near the word Standby.
In the Pick a Color dialog box, click the color for the standby span, or click the Reset button if you
want the standby span to display the last applied (saved) color.
Click OK to save the change and close the Preferences dialog box, or click Apply to save the change
and keep the Preferences dialog box open.
From the Edit menu, choose Preferences.
In the Preferences dialog box, click the Circuits tab.
Click Reset to Defaults.
Click OK to save the change and close the Preferences dialog box, or click Apply to save the change
and keep the Preferences dialog box open.
DLP-A232 Change Active and Standby Span Color
Step 4.
Step 5.
Step 6.
Cisco ONS 15454 Procedure Guide, R5.0
19-21