Chapter 14 Add And Remove Node - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:

Table of Contents

NTP-A212 Add a BLSR Node

Tools/Equipment

Prerequisite Procedures Cards must be installed and node turn-up procedures completed on the

Required/As Needed

Onsite/Remote

Security Level

Adding a BLSR node can be service affecting and should be performed during a maintenance window.

Draw a diagram of the BLSR where you will add the node. In the diagram, identify the east and west

BLSR OC-N trunk (span) cards that will connect to the new node. This information is essential to

complete this procedure without error.

that uses Slots 5 and 12 for the BLSR trunk cards. The dashed arrow shows the new fiber connections

that will be made to add the fourth node to the BLSR.

Cisco ONS 15454 Procedure Guide, R5.0

This procedure expands a BLSR by adding a node.

Fiber for new node connections

node that will be added to the BLSR. See

Fiber-Optic Cable,"

Provisioning or higher

Three-Node, Two-Fiber BLSR Before a Fourth Node Is Added

Working and protect fibers

New fiber connections

Chapter 4, "Turn Up Node."

shows a drawing of a three-node, two-fiber BLSR

Add and Remove Nodes

Chapter 2, "Install Cards and

December 2004

Chapters

Table of Contents