Chapter 8 Monitor Performance - Cisco ONS 15454 Series Procedure Manual

NTP-A253 Change the PM Display
NTP-A253 Change the PM Display
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with
In node view, double-click the electrical, Ethernet, or optical (OC-N) cards where you want to view PM
Step 2
counts. The card view appears.
As needed, use the following tasks to change the display of PM counts:
Step 3
•
•
•
•
•
•
•
•
•
•
•
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
8-2
This procedure enables you to change the display of PM counts by
selecting drop-down list or radio button options in the Performance
window.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and VT Tunnels"
As needed
Onsite or remote
Retrieve or higher
"DLP-A60 Log into CTC" task on page 17-66
DLP-A124 Refresh PM Counts at 15-Minute Intervals, page 18-11
DLP-A125 Refresh PM Counts at One-Day Intervals, page 18-11
DLP-A347 Refresh E-Series and G-Series Ethernet PM Counts, page 20-33
DLP-A126 View Near-End PM Counts, page 18-12
DLP-A127 View Far-End PM Counts, page 18-13
DLP-A348 Monitor PM Counts for a Selected Signal, page 20-34
DLP-A129 Reset Current PM Counts, page 18-13
DLP-A349 Clear Selected PM Counts, page 20-35
DLP-A260 Set Auto-Refresh Interval for Displayed PM Counts, page 19-43
DLP-A259 Refresh Ethernet PM Counts at a Different Time Interval, page 19-42
DLP-A261 Refresh PM Counts for a Different Port, page 19-43
and Chapter 11, "Change Card Settings."
at the node that you want to monitor. If you
Step 2.
Chapter 8 Monitor Performance
Chapter 6, "Create Circuits
December 2004