Ntp- A143 Create An E-Series Hub-And-Spoke Ethernet Configuration - Cisco ONS 15454 Series Procedure Manual

Chapter 6 Create Circuits and VT Tunnels
State—The circuit is in service (default).
•
Apply to drop ports—Uncheck this box; states cannot be applied to E-Series ports.
•
Protected Drops—Leave the default unchanged (unchecked).
•
If the circuit will be routed on a path protection, complete the
Step 11
Selectors" task on page
Click Next.
Step 12
Provision the circuit source:
Step 13
a. From the Node drop-down list, choose the hub node.
b. From the Slot drop-down list, choose the Ethernet card where you enabled the single-card
EtherSwitch.
Step 14 Click Next.
Provision the circuit destination:
Step 15
From the Node drop-down list, choose an EtherSwitch circuit endpoint node.
a.
From the Slot drop-down list, choose the Ethernet card where you enabled the single-card
b.
EtherSwitch.
Click Next.
Step 16
Review the VLANs listed in the Available VLANs list. If the VLAN you want to use appears, continue
Step 17
with Step
Click the New VLAN button.
a.
In the Define New VLAN dialog box, complete the following:
b.
•
•
•
Click OK.
c.
Tip
In the Available VLANs column, click the VLAN you want to use and click the arrow button (>>) to
Step 18
move the VLAN to the Circuit VLANs column.
Note
Click Next.
Step 19
In the left pane of the Circuit Routing Preferences panel, confirm that the following information is
Step 20
correct:
Circuit name
•
Circuit type
•
August 2005
19-12.
19. If you need to create a new VLAN, complete the following steps:
VLAN Name—Assign an easily identifiable name to your VLAN.
VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15454 network supports
a maximum of 509 user-provisionable VLANs.
Topology Host—Choose the topology host ID from the drop-down list.
You can also add VLANs in network view by choosing Tools > Manage VLANs. In the All
VLANs dialog box, click the Create button to open the Define New VLAN dialog box.
Moving the VLAN from Available VLANs to Circuit VLANs forces all the VLAN traffic to use
the shared packet ring you are creating.
NTP-A143 Create an E-Series Hub-and-Spoke Ethernet Configuration
"DLP-A218 Provision Path Protection
Cisco ONS 15454 Procedure Guide, R5.0
6-65