Figure - Cisco ONS 15454 Series Procedure Manual

Manage Circuits
The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
Note
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter explains how to manage Cisco ONS 15454 electrical, optical (OC-N), Ethernet, and virtual
concatenated (VCAT) circuits.
Before You Begin
To create circuits, see
To clear any alarm or trouble conditions, refer to the Cisco ONS 15454 Troubleshooting Guide.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
9.
December 2004
Chapter 6, "Create Circuits and VT Tunnels."
NTP-A199 Locate and View Circuits, page
NTP-A200 View Cross-Connect Card Resource Usage, page
NTP-A151 Modify and Delete Circuits, page
change the active and standby colors of spans; change signal fail, signal degrade thresholds,
reversion time, and PDI-P settings for path protection circuits; or add or delete a VCAT member.
NTP-A278 Modify and Delete Overhead Circuits, page
type, repair an IP circuit, or delete overhead circuits.
NTP-A78 Create a Monitor Circuit, page
bidirectional circuits.
NTP-A79 Create a J1 Path Trace, page
changes to circuit traffic.
NTP-A293 Create a J2 Path Trace, page
changes to circuit traffic.
NTP-A298 Reconfigure Circuits, page
NTP-A301 Merge Circuits, page
C H A P T E R
9-2—Complete as needed.
9-4—Complete as needed to edit a circuit name;
9-4—Complete as needed to change a tunnel
9-5—Complete as needed to monitor traffic on primary
9-6—Complete as needed to monitor interruptions or
9-7—Complete as needed to monitor interruptions or
9-9—Complete as needed to reconfigure circuits.
9-10—Complete as needed to merge circuits.
Cisco ONS 15454 Procedure Guide, R5.0
9-2—Complete as needed.
9
9-1