Cisco ONS 15454 Series Procedure Manual page 222

NTP-A140 Create a Half Circuit on a Path Protection Node
Complete the
Step 9
page
Click Finish. One of the following results occurs, depending on the circuit properties you chose in the
Step 10
Circuit Creation dialog box:
•
•
In the Circuits window, verify that the new circuits appear in the circuits list.
Step 11
Complete the
Step 12
Circuits" procedure on page
Stop. You have completed this procedure.
NTP-A140 Create a Half Circuit on a Path Protection Node
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
From the View menu, choose Go to Network View.
Step 3
Step 4 Click the Circuits tab, then click Create.
Step 5 In the Circuit Creation dialog box, complete the following fields:
•
•
•
Step 6 Click Next.
Cisco ONS 15454 Procedure Guide, R5.0
6-54
"DLP-A311 Provision a Half Circuit Source and Destination on a BLSR or 1+1" task on
20-5.
If you entered more than 1 in the number of Circuits field and selected Auto-ranged, CTC
automatically creates the number of circuits entered in Number of Circuits. If auto-ranging cannot
complete all the circuits, for example, because sequential ports are unavailable at the source or
destination, a dialog box appears. Set the new source or destination for the remaining circuits, then
click Finish to continue auto-ranging. After completing the circuits, the Circuits window appears.
If you entered more than 1 in the Number of Circuits field and did not choose Auto-ranged, the
Circuit Creation dialog box appears so you can create the remaining circuits. Repeat Steps
through 9 for each additional circuit. After completing the circuits, the Circuits window appears.
"NTP-A135 Test Electrical Circuits" procedure on page 6-36
6-51, as applicable. Skip this step if you built a test circuit.
This procedure creates a DS-1, DS-3, or OC-N circuit from a drop to an
OC-N line card on the same path protection node.
None
NTP-A127 Verify Network Turn Up, page 6-4
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A314 Assign a Name to a Port" task on page
Circuit Type—For DS-1 circuits, choose VT. VT cross-connects will carry the DS-1 circuit across
the ONS 15454 network. For DS-3 or OC-N circuits, choose STS. STS cross-connects will carry the
DS-3 circuit across the ONS 15454 network.
Number of Circuits—Enter the number of circuits you want to create. The default is 1.
Auto-ranged—Uncheck this check box; it is automatically selected if you enter more than 1 in the
Number of Circuits field.
Chapter 6
at the node where you will create the circuit.
Step 2.
20-8. If not, continue with
Create Circuits and VT Tunnels
5
or "NTP-A62 Test OC-N
Step 3.
August 2005