Cisco ONS 15454 Series Procedure Manual page 236

NTP-A144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect
•
•
Click OK.
c.
Tip
Step 18 Click the VLAN you want to use on the Available VLANs column, then click the arrow button (>>) to
move the VLAN to the Circuit VLANs column.
Click Next.
Step 19
In the left pane of the Circuit Routing Preferences panel, confirm that the following information about
Step 20
the single-card EtherSwitch manual cross-connect is correct (in this task, "circuit" refers to the Ethernet
cross-connect):
• Circuit name
Circuit type
•
Circuit size
•
VLAN names
•
ONS nodes
•
If the information is not correct, click the Back button and repeat Steps
Step 21
information. If the information is correct, check Route Automatically.
Click Finish.
Step 22
Complete the
Step 23
carries the circuit.
Complete the
Step 24
page 19-14
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
6-68
VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15454 network supports
a maximum of 509 user-provisionable VLANs.
Topology Host—Choose the topology host ID from the drop-down list.
You can also add VLANs in network view by choosing Tools > Manage VLANs. In the All
VLANs dialog box, click the Create button to open the Define New VLAN dialog box.
"DLP-A220 Provision E-Series Ethernet Ports" task on page 19-13
"DLP-A221 Provision E-Series Ethernet Ports for VLAN Membership" task on
for each node that carries the circuit.
Chapter 6 Create Circuits and VT Tunnels
8 through 20 with the correct
for each node that
August 2005