Dlp- A434 Lock Node Security - Cisco ONS 15454 Series Procedure Manual

DLP-A434 Lock Node Security
Click Finish.
Step 9
Within the next 30 to 40 seconds, the TCC2P cards reboot. CTC switches to network view, and the CTC
Alerts dialog box appears. In network view, the node color changes to grey and a DISCONNECTED
condition appears.
In the CTC Alerts dialog box, click Close. Wait for the reboot to finish (this might take several minutes).
Step 10
After the DISCONNECTED condition clears, complete the following steps to suppress the backplane IP
Step 11
address from display in CTC and the LCD. If you do not want to suppress the backplane IP address
display, continue with
a.
b.
c.
d.
e.
Note
Return to your originating procedure (NTP).
Step 12
DLP-A434 Lock Node Security
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This task is irreversible. Do not proceed unless you want the node to permanently have two IP addresses.
Caution
Click the Provisioning > Security > Data Comm tabs.
Step 1
Step 2 Click Lock.
Step 3 In the Confirm Lock Secure Mode dialog box, click Yes.
Return to your originating procedure (NTP).
Step 4
Cisco ONS 15454 Procedure Guide, R5.0
21-12
Step 12.
Display the node in node view.
Click the Provisioning > Security > Data Comm tabs.
In the LCD IP Setting field, choose Suppress Display. This removes the IP address from display on
the ONS 15454 LCD.
Check the Suppress CTC IP Address check box. This removes the IP address from display in the
CTC information area and from the Provisioning > Security > Data Comm tab.
Click Apply.
After you turn on secure mode, the TCC2P IP address becomes the node IP address.
This task locks the ONS 15454 security mode. When security mode is
locked, two IP addresses must always be provisioned for the node, one for
the TCC2P LAN (TCP/IP) port, and one for the backplane LAN port.
TCC2P cards must be installed.
DLP-A60 Log into CTC, page 17-66
DLP-A433 Enable Node Security Mode, page 21-11
As needed
Onsite or remote
Superuser
Chapter 21 DLPs A400 to A499
March 2005