Table 20-8 Line Options For The Ds3/Ec1-48Card - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
Modify any of the settings found under these subtabs. For definitions of the line settings, see
Step 4
For definitions of the line threshold settings, see
electrical path threshold settings, see
threshold settings, see
Step 5 Click Apply.
Repeat Steps
Step 6
Table 20-8
Table 20-8
Parameter
Port
Port Name
Admin State Sets the port service state unless network
March 2005
Table 20-11 on page
3 through 5 for each subtab that has parameters you want to provision.
describes the values on the Provisioning > Line tabs for the DS3/EC1-48 cards.
Line Options for the DS3/EC1-48Card
Description
Sets the port number.
Sets the port name.
conditions prevent the change.
DLP-A388 Change Line and Threshold Settings for the DS3/EC1-48 Cards
Table 20-9 on page
Table 20-10 on page 20-83. For definitions of the SONET
20-84.
Options
1 to 48
User-defined, up to 32 alphanumeric/special
characters. Blank by default.
See the
Port" task on page
IS—Puts the port in-service. The port
•
service state changes to IS-NR.
IS,AINS—Puts the port in automatic
•
in-service. The port service state
changes to OOS-AU,AINS.
OOS,DSBLD—Removes the port from
•
service and disables it. The port service
state changes to OOS-MA,DSBLD.
OOS,MT—Removes the port from
•
service for maintenance. The port
service state changes to OOS-MA,MT.
Cisco ONS 15454 Procedure Guide, R5.0
Table
20-83. For definitions of the
"DLP-A314 Assign a Name to a
20-8.
20-8.
20-81