Dlp- A526 Change Line And Threshold Settings For The Ds3I-N-12 Cards - Cisco ONS 15454 Series Procedure Manual

Chapter 22 DLPs A500 to A599
If you want to download a profile that is stored locally or on a network drive, click From File in the
Step 4
Load Profile(s) dialog box.
a.
b.
c.
Note
Note
Click OK.
Step 5
The downloaded profile appears at the right side of the Alarm Profiles window.
Step 6 Right-click anywhere in the downloaded profile column to view the profile editing shortcut menu.
Step 7 Click Store.
In the Store Profile(s) dialog box, click To Node(s).
Step 8
a.
b.
Step 9 Return to your originating procedure (NTP).
DLP-A526 Change Line and Threshold Settings for the DS3i-N-12 Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the DS3i-N-12 card where you want to change the line or threshold settings.
Step 1
Click the Provisioning tab.
Step 2
October 2005
Click Browse.
Navigate to the file location in the Open dialog box.
Click Open.
The Default alarm profile list contains alarm and condition severities that correspond, when
applicable, to default values established in Telcordia GR-253-CORE.
All default or user-defined severity settings that are CR or MJ are demoted to MN in NSA
situations as defined in Telcordia GR-474.
Choose the node(s) where you want to save the profile:
If you want to save the profile to only one node, click the node in the Node Names list.
•
If you want to save the profile to all nodes, click Select All.
•
If you do not want to save the profile to any nodes, click Select None.
•
If you want to update alarm profile information, click Synchronize.
•
Click OK.
This task changes the line and threshold settings for the DS3i-N-12 cards.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
DLP-A526 Change Line and Threshold Settings for the DS3i-N-12 Cards
Cisco ONS 15454 Procedure Guide, R5.0
22-21