Figure 17-25 Attaching A Fiber Boot - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
The fiber boot does not support the OC-48 IR/STM-16 SH AS 1310, OC-48 LR/STM-16 LH AS 1550,
Note
and OC-192 LR/STM64 LH 1550 cards. The boots are not necessary for these cards because of the
angled SC connectors on the cards.
If you are installing an OC3IR/STM1SH 1310-8 card, you must use a fiber clip instead of a fiber boot
Note
on the Port 8 Rx fiber connector.
Position the open slot of the fiber boot underneath the fiber cable.
Step 1
Push the fiber cable down into the fiber boot.
Step 2
Figure 17-25
Strain relief shroud
Step 3 Twist the fiber boot to lock the fiber cable into the tail end of the fiber boot.
Step 4 Slide the fiber boot forward along the fiber cable until the fiber boot fits snugly onto the end of the
SC cable connector.
Step 5 Return to your originating procedure (NTP).
March 2005
Attaching a Fiber Boot
SC cable
connector
Fiber
optic
line Fiber boot
Figure 17-25 shows the fiber boot attachment.
Cisco ONS 15454 Procedure Guide, R5.0
DLP-A45 Install the Fiber Boot
17-55