Ntp- A62 Test Oc-N Circuits - Cisco ONS 15454 Series Procedure Manual

NTP-A314 Create a Unidirectional OC-N Circuit with Multiple Drops
Complete the
Step 17
Click Finish. After completing the circuit, the Circuits window appears.
Step 18
In the Circuits window, click the circuit that you want to route to multiple drops. The Delete, Edit, and
Step 19
Search buttons become active.
Click Edit. The Edit Circuit window appears with the General tab selected. All nodes in the DCC
Step 20
network appear on the network map. Circuit source and destination information appears under the source
and destination nodes. To see a detailed view of the circuit, click Show Detailed Map. You can rearrange
the node icons by pressing Ctrl while you drag and drop the icon to the new location.
In the Edit Circuit dialog box, click the Drops tab. A list of existing drops appears.
Step 21
Click Create.
Step 22
In the Define New Drop dialog box, define the new drop:
Step 23
Node—Choose the target node for the circuit drop.
a.
Slot—Choose the target card and slot.
b.
Port, STS—Choose the port and/or STS from the Port and STS drop-down lists. The choice in these
c.
menus depends on the card selected in Step b. See
The routing preferences for the new drop match those of the original circuit. However, if the
d.
following options are available, you can modify them:
•
•
If you want to change the circuit state, choose the circuit state from the Target Circuit Admin State
e.
drop-down list. The state chosen applies to the entire circuit.
Check Apply to drop ports if you want to apply the state chosen in the Target Circuit Admin State
f.
to the circuit source and destination drops. For the requirements necessary to apply a service state
to drop ports, refer to the Cisco ONS 15454 Reference Manual.
Click Finish. The new drop appears in the Drops list.
g.
If you need to create additional drops on the circuit, repeat Steps
Step 24
Click Close. The Circuits window appears.
Step 25
Verify that the new drops appear in the Destination column for the circuit you edited. If they do not
Step 26
appear, repeat Steps
Complete the
Step 27
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
6-50
"DLP-A369 Provision an OC-N Circuit Route" task on page
If the original circuit was routed on a protected path protection path, you can change the nodal
diversity options: Nodal Diversity Required, Nodal Diversity Desired, or Link Diversity Only.
See Step 13 for option descriptions.
If the original circuit was not routed on a protected path, the Protection Channel Access option
is available. See Step 12 for a description of the PCA option.
22 through 25, making sure all options are provisioned correctly.
"NTP-A62 Test OC-N Circuits" procedure on page
Chapter 6 Create Circuits and VT Tunnels
20-53.
Table 6-2 on page 6-3 for a list of options.
21 through 23.
6-51.
August 2005