Subtended Blsrs On The Network Map - Cisco ONS 15454 Series Procedure Manual

NTP-A172 Create a Logical Network Map
Figure 5-14
Stop. You have completed this procedure.
NTP-A172 Create a Logical Network Map
Purpose
Tools
Prerequisite Procedures This procedure assumes that network turn-up is complete.
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
you want to create the network map. If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Change the position of the nodes in the network view according to your site plan.
Step 3
a.
b.
c.
On the network view map, right-click and choose Save Node Position.
Step 4
Click Yes in the Save Node Position dialog box.
Step 5
CTC displays a progress bar and saves the new node positions.
Note
Cisco ONS 15454 Procedure Guide, R5.0
5-40

Subtended BLSRs on the Network Map

This procedure positions nodes in the network view and allows a Superuser
to create a consistent network view for all nodes on the network.
None
As needed
Onsite or remote
Superuser
"DLP-A60 Log into CTC" task on page 17-66
Click a node to select it, then press the Ctrl key while you drag and drop a node icon to a new
location.
Deselect the previously selected node by clicking on any blank part of the network map area.
Repeat Step a for each node you need to position.
Retrieve, Provisioning, and Maintenance users can move nodes on the network map, but only
Superusers can save new network map configurations. To restore the view to a previously saved
version of the network map, right-click on the network view map and choose Reset Node
Position.
Chapter 5
on an ONS 15454 on the network where
Turn Up Network
December 2004