Dlp- A75 Create A New User On Multiple Nodes - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
•
•
•
•
Note
Click OK.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-A75 Create a New User on Multiple Nodes
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
All nodes where you want to add users must be accessible in network view.
Note
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > Security > Users tabs.
Step 2
In the Users window, click Create.
Step 3
In the Create User dialog box, enter the following:
Step 4
•
March 2005
Name—Type the user name. The name must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) characters. For TL1 compatibility, the user name must be
6 to 10 characters.
Password—Type the user password. The password must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) and special (+, #,%) characters, where at least two characters are
nonalphabetic and at least one character is a special character. For TL1 compatibility, the password
must be 6 to 10 characters. The password must not contain the user name.
Confirm Password—Type the password again to confirm it.
Security Level—Choose a security level for the user: RETRIEVE, MAINTENANCE,
PROVISIONING, or SUPERUSER. Refer to the "Security and Timing" chapter in the
Cisco ONS 15454 Reference Manual for information about the capabilities provided with each level.
Each security level has a different idle time. The idle time is the length of time that CTC can
remain idle before the password must be reentered. The defaults are: Retrieve user = unlimited,
Maintenance user = 60 minutes, Provisioning user = 30 minutes, and Superuser = 15 minutes.
To change the idle times, refer to the
on page 10-6.
This task adds a new user to multiple ONS 15454s.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Superuser
Name—Type the user name. The name must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) characters. For TL1 compatibility, the user name must
6 to 10 characters.
DLP-A75 Create a New User on Multiple Nodes
"NTP-A205 Modify Users and Change Security" procedure
Cisco ONS 15454 Procedure Guide, R5.0
17-83