Dlp- A26 Install Coaxial Cable With High-Density Bnc Connectors - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
Metallic interfaces for connection to outside plant lines (such as T1/E1/T3/E3 etc.) must be connected
Warning
through a registered or approved device such as CSU/DSU or NT1. Statement 290
Label all cables at each end of the connection to avoid confusion with cables that are similar in
Step 7
appearance.
Return to your originating procedure (NTP).
Step 8
DLP-A26 Install Coaxial Cable With High-Density BNC Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Place the cable connector over the desired connection point on the backplane.
Step 1
Using the BNC insertion tool, position the cable connector so that the slot in the connector is over the
Step 2
corresponding notch at the backplane connection point.
Gently push the connector down until the notch backplane connector slides into the slot on the cable
Step 3
connector.
Turn the cable connector clockwise to lock it into place.
Step 4
Tie wrap or lace the cables to the EIA according to Telcordia standards (GR-1275-CORE) or local site
Step 5
practice.
Route the cables to the nearest side of the shelf assembly through the side cutouts according to local site
Step 6
practice.
The rubber-coated edges of the side cutouts prevent the cables from chafing.
Step 7 Return to your originating procedure (NTP).
DLP-A27 Install Coaxial Cable with SMB Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
March 2005
DLP-A26 Install Coaxial Cable With High-Density BNC Connectors
This task installs the coaxial cable with high-density BNC connectors.
BNC insertion tool
DLP-A12 Install a BNC or High-Density BNC EIA, page 17-12
As needed
Onsite
None
This task installs the coaxial cable with SMB connectors.
SMB cable connector
DLP-A13 Install an SMB EIA, page 17-15
As needed
Onsite
None
Cisco ONS 15454 Procedure Guide, R5.0
17-33