Dlp- A89 Remap The K3 Byte - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
DLP-A89 Remap the K3 Byte
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If you remap the K3 byte, remap to the same extended byte (Z2, E2, or F1) on both sides of the span.
Caution
Step 1 In node view, double-click the OC-48 AS card that connects to the third-party equipment.
Step 2 Click the Provisioning > Line tabs.
Click BLSR Ext Byte and choose the alternate byte: Z2, E2, or F1.
Step 3
Click Apply.
Step 4
For four-fiber BLSRs only, repeat Steps
Step 5
Repeat this task at the node and card on the other end of the BLSR span.
Step 6
Note
Return to your originating procedure (NTP).
Step 7
DLP-A91 BLSR Switch Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Step 2 Click the Provisioning > BLSR tabs.
Click the row of the BLSR you will switch, then click Edit.
Step 3
March 2005
This task provisions the K3 byte. Do not remap the K3 byte unless
specifically required to run an ONS 15454 BLSR through third-party
equipment. This task is unnecessary for most users.
OC-48 AS cards must be installed on the BLSR span that you remap.
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
The extension byte chosen in Step
This task verifies that protection switching is working correctly in a BLSR.
None
DLP-A60 Log into CTC, page 17-66
Required
Onsite or remote
Provisioning or higher
2 through 4 for each protect card.
3 should match at both ends of the span.
Cisco ONS 15454 Procedure Guide, R5.0
DLP-A89 Remap the K3 Byte
17-87