Cisco ONS 15454 Series Procedure Manual page 159

Chapter 5 Turn Up Network
page
equipment. For example in
cards/ports:
•
•
•
Note
Repeat Steps
Step 5
As needed, complete the
Step 6
As needed, complete the
Step 7
Following the documentation provided by the third-party vendor, provision the optical loop leading from
Step 8
the ONS 15454 connection at one end to the ONS 15454 connection at the other end. In other words,
you will create an open-ended path protection using procedures for the third-party equipment.
Complete the
Step 9
Stop. You have completed this procedure.
NTP-A225 Open-Ended Path Protection Acceptance Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution This procedure might be service affecting if performed on a node carrying traffic.
Complete the
Step 1
traffic traversing the third-party network. If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Click the Alarms tab.
Step 3
a.
b.
c.
December 2004
20-62.) Do not create DCC or LDCC terminations for the card/port that connects to the third-party
Figure 5-11 on page
Nodes 1 and 6: Slot 5 and Slot 12
Node 2 and 5: Slot 12
Node 3 and 4: Slot 5
If an ONS 15454 is not connected to a corporate LAN, DCC or LDCC provisioning must be
performed through a direct (craft) connection. Remote provisioning is possible only after all
nodes in the network have DCC or LDCC terminations provisioned to in-service OC-N ports.
3 and 4 for each node in the path protection.
"DLP-A380 Provision a Proxy Tunnel" task on page
"DLP-A381 Provision a Firewall Tunnel" task on page
"NTP-A225 Open-Ended Path Protection Acceptance Test" procedure on page
This procedure tests an open-ended path protection.
Test set and cables appropriate to the test circuit you will create.
NTP-A224 Provision an Open-Ended Path Protection, page 5-31
As needed
Onsite
Provisioning and higher
"DLP-A60 Log into CTC" task on page 17-66
Verify that the alarm filter is not on. See the
page 19-17 as necessary.
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
Complete the "DLP-A516 Export CTC Data" task on page 22-6
NTP-A225 Open-Ended Path Protection Acceptance Test
5-32, DCC terminations are created at the following
at the node that will be the source node for
"DLP-A227 Disable Alarm Filtering" task on
to export the alarm information.
Cisco ONS 15454 Procedure Guide, R5.0
20-63.
20-64.
5-33.
5-33