Dlp- A175 Change Orderwire Settings Using The Aic Card - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
Click the Provisioning > External Controls tabs.
Step 3
Modify any of the following fields for each external control wired to the ONS 15454 backplane. For
Step 4
definitions of these fields, see the
Interface Controller" procedure on page
•
•
•
•
To provision additional controls, complete
Step 5
Click Apply.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-A175 Change Orderwire Settings Using the AIC Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
When provisioning orderwire for ONS 15454s residing in a ring, do not provision a complete orderwire
Caution
loop. For example, a four-node ring typically has east and west ports provisioned at all four nodes.
However, to prevent orderwire loops, provision two orderwire ports (east and west) at all but one of the
ring nodes.
Before you begin, make a list of the ONS 15454 slots and ports that require orderwire communication.
Tip
In node view, double-click the AIC card to display it in card view.
Step 1
Click the Provisioning > Local Orderwire tabs or Provisioning > Express Orderwire tabs, depending
Step 2
on the orderwire path that you want to create.
If needed, adjust the Tx and Rx dBm by moving the slider to the right or left for the headset type
Step 3
(four-wire or two-wire) that you will use. In general, you should not need to adjust the dBm.
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
March 2007
Enabled
Trigger Type
Control Type
Description
This task changes orderwire settings on the AIC card.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
DLP-A175 Change Orderwire Settings Using the AIC Card
"NTP-A32 Provision External Alarms and Controls on the Alarm
7-9.
Step 4 for each additional device.
Cisco ONS 15454 Procedure Guide, R5.0
18-55