Dlp- A171 Change Threshold Settings For Oc-N Cards - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
Table 18-21
Parameter
AINS Soak
Type
ALS Mode
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-A171 Change Threshold Settings for OC-N Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the OC-N card where you want to change the threshold settings.
Step 1
Click the Provisioning > SONET Thresholds tabs.
Step 2
Modify any of the settings found in
Step 3
Table 18-22
Parameter
Port
CV
March 2007
OC-N Card Line Settings (continued)
Description
Sets the automatic in-service
soak period.
Defines the port as SONET or
SDH. The Enable Sync Msg field
and the Send Do Not Use field
must be disabled before the port
can be set to SDH.
Sets the automatic laser
shutdown function.
This task changes threshold settings for OC-N cards.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Table
OC-N Threshold Options
Description
Port number
Coding violations
DLP-A171 Change Threshold Settings for OC-N Cards
Options
Duration of valid input signal, in hh.mm format,
•
after which the card becomes IS automatically
0 to 48 hours, 15-minute increments
•
Sonet
•
SDH
•
Disabled
•
Auto Restart
•
Manual Restart
•
Manual Restart for Test
•
18-22.
Options
1 (OC-12, OC-48, OC-192)
•
1-4 (OC-3, OC12-4)
•
Numeric. Can be set for 15-minute or
one-day intervals for Line, Section, or
Path (Near and Far End). Select the bullet
and click Refresh.
Cisco ONS 15454 Procedure Guide, R5.0
18-51