Dlp- A437 Change A Vcat Member Service State - Cisco ONS 15454 Series Procedure Manual

Chapter 21 DLPs A400 to A499
Return to your originating procedure (NTP).
Step 9
DLP-A437 Change a VCAT Member Service State
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
CTC only permits you to change the state of a non-Link Capacity Adjustment Scheme (LCAS) member
Note
if the new state matches the In Group VCAT state of the other members, or if the new state is an
Out of Group VCAT state. The In Group VCAT state indicates that a member has cross-connects in the
IS-NR; OOS-MA,AINS; or OOS-AU,MT service states. For non-LCAS VCAT members, the Out of
Group VCAT state is the OOS-MA,DSBLD service state.
Step 1 In node or network view, click the Circuits tab.
Step 2 Click the VCAT circuit that you want to edit, then click Edit.
Click the Members tab.
Step 3
Select the member that you want to change. To choose multiple members, press Ctrl and click each
Step 4
member.
From the Tools menu, choose Set Circuit State.
Step 5
Note
From the Target Circuit Admin State drop-down list, choose the administrative state:
Step 6
•
•
•
March 2005
This task displays the Edit Circuit window for VCAT members, where you
can change the service state.
None
DLP-A60 Log into CTC, page 17-66
VCAT circuits must exist on the network. See the
Automatically Routed VCAT Circuit" procedure on page 6-86
"NTP-A265 Create a Manually Routed VCAT Circuit" procedure on
page
As needed
Onsite or remote
Provisioning or higher
You can also change the state for all members listed in the Edit Circuit window using the State
tab. Another alternative is to click the Edit Member button to access the Edit Member Circuit
window for the selected member, and click the State tab.
IS—Puts the member cross-connects in the IS-NR service state.
OOS,DSBLD—Puts the member cross-connects in the OOS-MA,DSBLD service state. Traffic is
not passed on the circuit.
IS,AINS—Puts the member cross-connects in the OOS-AU,AINS service state and suppresses
alarms and conditions. When the connections receive a valid signal, the service state automatically
changes to IS-NR.
6-90.
Cisco ONS 15454 Procedure Guide, R5.0
DLP-A437 Change a VCAT Member Service State
"NTP-A264 Create an
or the
21-15