Cisco ONS 15454 Series Procedure Manual page 138

NTP-A126 Create a BLSR
Complete the
Step 10
Stop. You have completed this procedure.
NTP-A126 Create a BLSR
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the BLSR.
Complete one of the following tasks:
Step 2
•
•
•
•
Complete the
Step 3
"NTP-A176 Four-Fiber BLSR Acceptance Test" procedure on page
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
5-12
"NTP-A126 Create a BLSR" procedure on page
This procedure creates a BLSR at each BLSR-provisioned node.
None
NTP-A40 Provision BLSR Nodes, page 5-10
As needed; required to complete BLSR provisioning
Onsite or remote
Provisioning and higher
"DLP-A60 Log into CTC" task on page 17-66
DLP-A328 Create a Two-Fiber BLSR Using the BLSR Wizard, page 20-17
a two-fiber BLSR using the CTC BLSR wizard. The BLSR wizard checks to see that each node is
ready for BLSR provisioning, then provisions all the nodes at once. Using the BLSR wizard is
recommended.
DLP-A362 Create a Four-Fiber BLSR Using the BLSR Wizard, page
a four-fiber BLSR using the CTC BLSR wizard. The BLSR wizard checks to see that each node is
ready for BLSR provisioning, then provisions all the nodes at once. Using the BLSR wizard is
recommended.
DLP-A329 Create a Two-Fiber BLSR Manually, page
BLSR manually at each node that will be in the BLSR.
DLP-A363 Create a Four-Fiber BLSR Manually, page
BLSR manually at each node that will be in the BLSR.
"NTP-A175 Two-Fiber BLSR Acceptance Test" procedure on page 5-13
Chapter 5
5-12.
at a node on the network where you will
– Use this task to create
20-46—Use this task to create
20-18— Use this task to provision a two-fiber
20-48—Use this task to provision a four-fiber
5-15.
Turn Up Network
or the
December 2004