Table 22-1 Line Options For The Ds3I-N-12 Cards - Cisco ONS 15454 Series Procedure Manual

DLP-A526 Change Line and Threshold Settings for the DS3i-N-12 Cards
Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
Step 3
or SONET Thresholds subtab.
Note
Modify any of the settings found under these subtabs. For definitions of the line settings, see
Step 4
For definitions of the line threshold settings, see
threshold settings, see
Click Apply.
Step 5
Repeat Steps
Step 6
Table 22-1
Table 22-1
Parameter
Port #
Port Name
SF BER
SD BER
Line Type
Detected
Line Type
Line
Coding
Cisco ONS 15454 Procedure Guide, R5.0
22-22
See Chapter 7, "Manage Alarms"
Table 22-3. For definitions of the SONET threshold settings, see
3 through 5 for each subtab that has parameters you want to provision.
describes the values on the Provisioning > Line tabs for the DS3i-N-12 cards.
Line Options for the DS3i-N-12 Cards
Description
(Display only.) Shows the
port number.
Sets the port name.
Sets the signal fail bit error
rate.
Sets the signal degrade bit
error rate.
Defines the line framing
type.
(Display only.) Displays
the detected line type.
(Display only.) Defines the
DS3E transmission coding
type.
for information about the Alarm Behavior tab.
Table 22-2. For definitions of the electrical path
Options
1 to 12
User-defined, up to 32 alphanumeric/ special characters.
Blank by default.
See the "DLP-A314 Assign a Name to a Port" task on
page 20-8.
1E-3
•
• 1E-4
• 1E-5
1E-5
•
1E-6
•
1E-7
•
1E-8
•
1E-9
•
Unframed
•
M13
•
C Bit
•
Auto Provisioned
•
M13
•
• C Bit
• Unframed
Unknown
•
B3ZS
Chapter 22 DLPs A500 to A599
Table 22-1.
Table 22-4.
October 2005