Ntp- A153 Upgrade The Aic Card To Aic-I - Cisco ONS 15454 Series Procedure Manual

NTP-A153 Upgrade the AIC Card to AIC-I
Stop. You have completed this procedure.
NTP-A153 Upgrade the AIC Card to AIC-I
Purpose
Tools
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Physically remove the AIC card:
Step 1
a.
b.
Complete the
Step 2
Controller–International Card" task on page
Complete the
Step 3
Controller-International" procedure on page
Stop. You have completed this procedure.
NTP-A94 Upgrade OC-N Cards and Spans Automatically
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Cisco ONS 15454 Procedure Guide, R5.0
12-12
This procedure upgrades an AIC card to an AIC-I card; the AIC-I card
provides additional alarm contacts.
None
DLP-A38 Install the Alarm Interface Controller or Alarm Interface
Controller–International Card, page 17-47
As needed
Onsite
Maintenance or higher
Open the AIC card ejectors.
Slide the card out of the slot.
After several seconds this raises the
complete.
"DLP-A38 Install the Alarm Interface Controller or Alarm Interface
"NTP-A258 Provision External Alarms and Controls on the Alarm Interface
This procedure upgrades cards, two-fiber BLSR spans, four-fiber BLSR
spans, path protection spans, and 1+1 protection group spans. The Span
Upgrade Wizard only supports OC-N span upgrades. It does not support
electrical upgrades.
Higher-rate cards
Compatible hardware necessary for the upgrade (for example, XC10G
cards and OC-48 any slot cards)
Attenuators might be needed for some applications
The span upgrade procedure requires at least two technicians (one at
each end of the span) who can communicate with each other during the
upgrade.
As needed
alarm, which will clear when the downgrade is
IMPROPRMVL
17-47.
7-11.
Chapter 12 Upgrade Cards and Spans
January 2005