Dlp- A222 Provision G-Series Ethernet Ports - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

DLP-A222 Provision G-Series Ethernet Ports
DLP-A222 Provision G-Series Ethernet Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
In the node view, double-click the G-Series card graphic to open the card.
Click the Provisioning > Port tabs.
Step 2
For each G-Series port, provision the following parameters:
Step 3
Step 4
Payload Type—Click in the Payload Type field and select a cyclic redundancy check (CRC) size to set
the G-Series card's LEX encapsulation:
Click Apply.
Step 5
Refresh the Ethernet statistics:
Step 6
a.
b.
Note
Return to your originating procedure (NTP).
Step 7
Cisco ONS 15454 Procedure Guide, R5.0
19-16
This task provisions G-Series Ethernet ports to carry traffic.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Port Name—If you want to label the port, type the port name.
Admin State—Select the service state for the port. See the
a Port" task on page 19-9
Auto Negotiation—Click this check box to enable autonegotiation on the port (default). If you do
not want to enable autonegotiation control, uncheck the box.
Flow Control—Click this check box to enable flow control on the port (default). If you do not want
to enable flow control, uncheck the box. To set custom flow control watermarks, see the
Provision G-Series Flow Control Watermarks" task on page
Max Size—To permit the acceptance of jumbo size Ethernet frames, choose Jumbo (default). If you
do not want to permit jumbo size Ethernet frames, choose 1548.
The maximum frame size of 1548 bytes enables the port to accept valid Ethernet frames that
Note
use protocols, such as Inter-Switch Link (ISL). ISL adds 30 bytes of overhead and might
cause the frame size to exceed the traditional 1518 byte maximum.
LEX-FCS-16 is 16-bit (2 byte) CRC.
LEX-FCS-32 is 32-bit (4 byte) CRC.
Click the Performance > Statistics tabs.
Click Refresh.
Reprovisioning an Ethernet port on the G-Series card does not reset the Ethernet statistics for
that port.
for more information.
Chapter 19
DLPs A200 to A299
"DLP-A214 Change the Service State for
21-7.
"DLP-A421
September 2005

Advertisement

Table of Contents
loading

Table of Contents