Chapter 5 Turn Up Network - Cisco ONS 15454 Series Procedure Manual

NTP-A35 Verify Node Turn-Up
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
NTP-A35 Verify Node Turn-Up
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
already logged in, continue with Step 2.
Click the Alarms tab.
Step 2
a.
b.
Verify that the SW Version and Defaults shown in the node view status area match the software version
Step 3
and NE defaults shown in your site plan. If either is not correct, complete the following procedures as
needed:
Cisco ONS 15454 Procedure Guide, R5.0
5-2
NTP-A179 Provision an Integrated BLSR Dual-Ring Interconnect, page
complete this procedure after you provision a BLSR.
NTP-A44 Provision Path Protection Nodes, page
NTP-A177 Path Protection Acceptance Test, page
a path protection.
NTP-A216 Provision a Traditional Path Protection Dual-Ring Interconnect, page
complete this procedure after you provision a path protection.
NTP-A217 Provision an Integrated Path Protection Dual-Ring Interconnect, page
complete this procedure after you provision a path protection.
NTP-A180 Provision a Traditional BLSR/Path Protection Dual-Ring Interconnect, page
needed, complete this procedure after you provision a path protection and BLSR.
NTP-A209 Provision an Integrated BLSR/Path Protection Dual-Ring Interconnect, page
needed, complete this procedure after you provision a path protection and BLSR.
NTP-A224 Provision an Open-Ended Path Protection, page
procedure after you provision a path protection.
NTP-A225 Open-Ended Path Protection Acceptance Test, page
procedure after you provision an open-ended path protection.
NTP-A46 Subtend a Path Protection from a BLSR, page
NTP-A47 Subtend a BLSR from a Path Protection, page
NTP-A48 Subtend a BLSR from a BLSR, page
NTP-A172 Create a Logical Network Map, page
This procedure verifies that an ONS 15454 is ready for network turn-up
before adding it to a network.
None
Chapter 4, "Turn Up Node"
Required
Onsite
Provisioning and higher
"DLP-A60 Log into CTC" task on page 17-66
Verify that the alarm filter is not on. See the
page 19-17 as necessary.
Verify that no unexplained alarms appear on the network. If alarms appear, investigate and resolve
them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide for procedures.
5-20—Complete as needed.
5-22—Complete this procedure after you create
5-31—As needed, complete this
5-33—As needed, complete this
5-36—Complete as needed.
5-37—Complete as needed.
5-38—Complete as needed.
5-40—Complete as needed.
on the network you will test. If you are
"DLP-A227 Disable Alarm Filtering" task on
Chapter 5 Turn Up Network
5-19—As needed,
5-24—As needed,
5-26—As needed,
5-27—As
5-30—As
December 2004