Dlp- A397 Manually Route A Path Protection Circuit For A Topology Upgrade - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
DLP-A397 Manually Route a Path Protection Circuit for a Topology Upgrade
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the Circuit Routing Preferences area of the Unprotected to UPSR page, uncheck
Step 1
Route Automatically.
Click Next. In the Route Review and Edit area, node icons appear for you to route the circuit. The circuit
Step 2
source node is selected. Green arrows pointing from the source node to other network nodes indicate
spans that are available for routing the circuit.
Click Finish.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-A398 Automatically Route a Path Protection Circuit for a Topology Upgrade
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the Circuit Routing Preferences area of the Unprotected to UPSR page, check Route Automatically.
Step 1
Two options are available; choose either, both, or none based on your preferences.
Step 2
•
•
March 2005
This task creates a manually routed USPR circuit during a conversion
from an unprotected point-to-point or linear add/drop multiplexer
(ADM) system to a path protection.
None
DLP-A60 Log into CTC, page 17-66
NTP-A299 Convert a Point-to-Point or Linear ADM to a Path Protection
Automatically, page 13-11
As needed
Onsite or remote
Provisioning or higher
This task creates an automatically routed USPR circuit during a
conversion from an unprotected point-to-point or linear ADM system to
a path protection.
None
DLP-A60 Log into CTC, page 17-66
NTP-A299 Convert a Point-to-Point or Linear ADM to a Path Protection
Automatically, page 13-11
As needed
Onsite or remote
Provisioning or higher
Review Route Before Creation—Check this check box if you want to review and edit the circuit
route before the circuit is created.
VT-DS3 Mapped Conversion—(STS circuits only.) Check this check box to create a circuit using
the portless transmultiplexing interface of the DS3XM-12 card.
DLP-A397 Manually Route a Path Protection Circuit for a Topology Upgrade
Cisco ONS 15454 Procedure Guide, R5.0
20-95