Ntp- A218 Change The Node Timing Reference - Cisco ONS 15454 Series Procedure Manual

NTP-A218 Change the Node Timing Reference
NTP-A218 Change the Node Timing Reference
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
switching. If you are already logged in, continue with
Complete the
Step 2
needed.
Complete the
Step 3
page 20-13
Stop. You have completed this procedure.
NTP-A223 View the ONS 15454 Timing Report
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
timing status. If you are already logged in, continue with
Click the Maintenance > Timing > Report tabs.
Step 2
In the Timing Report area, you can view node timing information. The date and time of the report appear
Step 3
at the top of the report. The time stamp is the same as the alarms time stamp and can be configured using
the
page 15-19
Step 4 To update the report, click Refresh.
Cisco ONS 15454 Procedure Guide, R5.0
15-18
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A322 Manual or Force Switch the Node Timing Reference" task on page 20-13
"DLP-A323 Clear a Manual or Force Switch on a Node Timing Reference" task on
as needed.
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A112 Display Alarms and Conditions Using Time Zone" task on page
describes the report fields and entries.
This procedure enables automatic timing reference switching or returns
the node timing to normal operation.
None
NTP-A28 Set Up Timing, page 4-9
As needed
Onsite or remote
Maintenance or higher
Step
This procedure displays the current status of the ONS 15454 timing
references.
None
NTP-A28 Set Up Timing, page 4-9
As needed
Onsite or remote
Retrieve or higher
Chapter 15
at the node where you want to enable timing
2.
at the node where you want to view the node
Step 2.
18-3.
Maintain the Node
as
Table 15-2 on
December 2004