Cisco ONS 15454 Series Procedure Manual page 69

Chapter 1 Install the Shelf and Backplane Cable
Onsite/Remote
Security Level
Note The AIC-I card provides direct alarm contacts (external alarm inputs and external control outputs). In
the ANSI shelf, these AIC-I alarm contacts are routed through the backplane to wire-wrap pins
accessible from the back of the shelf. When you install an AEP, the direct AIC-I alarm contacts cannot
be used. Only the AEP alarm contacts can be used.
Remove the two backplane screws. Replace the two screws with standoffs. Insert the longer standoff on
Step 1
the left and the shorter standoff on the right
Figure 1-2
Longer
Step 2 Attach the remaining two standoffs on either side of the backplane
Step 3 Position the AEP board over the standoffs.
March 2005
Onsite
None
Replace Backplane Screws with Standoffs
Shorter
NTP-A119 Install the Alarm Expansion Panel
(Figure 1-2).
(Figure
Cisco ONS 15454 Procedure Guide, R5.0
1-3).
1-13