Dlp- A348 Monitor Pm Counts For A Selected Signal - Cisco ONS 15454 Series Procedure Manual

DLP-A348 Monitor PM Counts for a Selected Signal
DLP-A348 Monitor PM Counts for a Selected Signal
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Step 2 Click the Performance tab.
Note
In the signal type drop-down lists, click the following options as appropriate:
Step 3
•
•
•
Figure 20-5
card.
Cisco ONS 15454 Procedure Guide, R5.0
20-34
Different port and signal-type drop-down lists appear depending on the card type and the circuit
type. The appropriate types (DS1, DS3, VT path, STS path) appear based on the card. For
example, the DS3XM cards list DS3, DS1, VT path, and STS path PM parameters as signal
types. This enables you to select both the DS-3 port and the DS-1 within the specified DS-3.
DS: n or Port: n (card port number)
VT: n (VT path number)
STS: n (STS number within the VT path)
shows the port and signal type drop-down lists on the Performance window for a DS3XM-6
This task enables you to view near-end or far-end PM counts for a
specific signal (STSn), path (VTn), and port (DSn) on a selected card.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
Chapter 20 DLPs A300 to A399
March 2005