DLP-A388 Change Line and Threshold Settings for the DS3/EC1-48 Cards
Table 20-8
Parameter
Service
State
SF BER
SD BER
Line Type
Detected
Line Type
Line Coding Defines the DS-3 transmission coding
Cisco ONS 15454 Procedure Guide, R5.0
20-82
Line Options for the DS3/EC1-48Card (continued)
Description
Identifies the autonomously generated
state that gives the overall condition of
the port. Service states appear in the
format: Primary State-Primary State
Qualifier, Secondary State.
Sets the signal fail bit error rate.
Sets the signal degrade bit error rate.
Defines the line framing type.
(Display only.) Displays the detected line
type.
type that is used.
Chapter 20
Options
IS-NR—(In-Service and Normal) The
•
port is fully operational and performing
as provisioned.
OOS-AU,AINS—(Out-Of-Service and
•
Autonomous, Automatic In-Service)
The port is out-of-service, but traffic is
carried. Alarm reporting is suppressed.
The ONS node monitors the ports for an
error-free signal. After an error-free
signal is detected, the port stays in
OOS-AU,AINS state for the duration of
the soak period. After the soak period
ends, the port service state changes to
IS-NR.
OOS-MA,DSBLD—(Out-of-Service
•
and Management, Disabled) The port is
out-of-service and unable to carry
traffic.
OOS-MA,MT—(Out-of-Service and
•
Management, Maintenance) The port is
out-of-service for maintenance. Alarm
reporting is suppressed, but traffic is
carried and loopbacks are allowed.
1E-3
•
1E-4
•
1E-5
•
•
1E-5
1E-6
•
1E-7
•
1E-8
•
1E-9
•
Unframed - default
•
M13
•
C BIT
•
Auto Provision Fmt
•
M13
•
C Bit
•
Unframed
•
Unknown
•
B3ZS
DLPs A300 to A399
March 2005