Ntp- A293 Create A J2 Path Trace - Cisco ONS 15454 Series Procedure Manual

Chapter 9 Manage Circuits
Complete the
Step 1
create the path trace. If you are already logged in, continue with Step 2.
Complete the following tasks as needed:
Step 2
•
•
Stop. You have completed this procedure.
NTP-A293 Create a J2 Path Trace
Purpose
Tools/Equipment
Prerequisite Procedures See
Required/As Needed
Onsite/Remote
Security Level
You cannot create a J2 path trace on a TL1-like circuit.
Note
This procedure assumes you are setting up path trace on a bidirectional circuit and setting up transmit
Note
strings at the circuit source and destination.
Complete the
Step 1
create the path trace. If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Click the Circuits tab.
Step 3
For the VT circuit you want to monitor, verify that the source and destination ports are on a card that can
Step 4
transmit and receive the path trace string.
Note
Choose the VT circuit you want to trace, then click Edit.
Step 5
In the Edit Circuit window, click the Show Detailed Map check box at the bottom of the window. A
Step 6
detailed map of the source and destination ports appears.
December 2004
"DLP-A60 Log into CTC" task on page 17-66
As needed, complete the "DLP-A264 Provision a J1 Path Trace on Circuit Source and Destination
Ports" task on page 19-46.
As needed, complete the "DLP-A137 Provision Path Trace on OC-N Ports" task on page
This procedure creates a repeated, fixed-length string of characters used to
monitor interruptions or changes to circuit traffic.
DS3XM-12 card
procedures.
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
If neither port is on a transmit/receive card, you will not be able to complete this procedure. If
one port is on a transmit/receive card and the other is on a receive-only card, you can set up the
transmit string at the transmit/receive port and the receive string at the receive-only port, but you
will not be able to transmit in both directions.
Chapter 6, "Create Circuits and VT Tunnels"
NTP-A293 Create a J2 Path Trace
at a node on the network where you will
for DS-3 circuit creation
at a node on the network where you will
Cisco ONS 15454 Procedure Guide, R5.0
18-15.
9-7