Dlp- A324 Provision A Vcat Circuit Source And Destination - Cisco ONS 15454 Series Procedure Manual

DLP-A324 Provision a VCAT Circuit Source and Destination
Find the Clock reference that is currently set to Manual or Force in the Operation menu.
Step 2
From the Operation drop-down list choose Clear.
Step 3
Click Apply.
Step 4
Click Yes in the confirmation dialog box. If the normal timing reference is an acceptable valid reference,
Step 5
the node switches back to the normal timing reference as defined by the system configuration.
If the normal timing reference is invalid or has failed, a warning dialog box appears. Click OK; the
Step 6
timing reference does not revert.
Return to your originating procedure (NTP).
Step 7
DLP-A324 Provision a VCAT Circuit Source and Destination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Node drop-down list, choose the node where the circuit will originate.
Step 1
From the Slot drop-down list, choose the slot containing the CE-100T-8, ML-Series, or FC_MR-4 card
Step 2
where the circuit originates. (If a card's capacity is fully utilized, it does not appear in the list.)
Depending on the circuit origination card, choose the source port and/or STS and, if applicable, VT from
Step 3
the Port and STS drop-down lists. The Port drop-down list is only available if the card has multiple ports.
STSs do not appear if they are already in use by other circuits. VTs do not appear for STS-V circuits or
if they are already in use by other circuits.
Click Next.
Step 4
From the Node drop-down list, choose the destination node.
Step 5
From the Slot drop-down list, choose the slot containing the CE-100T-8, ML-Series, or FC_MR-4 card
Step 6
where the circuit will terminate (destination card). (If a card's capacity is fully utilized, the card does
not appear in the list.)
Depending on the card selected in
Step 7
the Port and STS drop-down lists. The Port drop-down list is only available if the card has multiple ports.
STSs do not appear if they are already in use by other circuits. VTs do not appear for STS-V circuits or
if they are already in use by other circuits.
Click Next.
Step 8
Return to your originating procedure (NTP).
Step 9
Cisco ONS 15454 Procedure Guide, R5.0
20-14
This task provisions a virtual concatenated (VCAT) circuit source and
destination.
None
DLP-A60 Log into CTC, page 17-66
The Circuit Creation wizard Circuit Source page must be open.
As needed
Onsite or remote
Provisioning or higher
Step 2, choose the source port and/or STS and, if applicable, VT from
Chapter 20 DLPs A300 to A399
March 2005