Ntp- A168 Enable, Modify, Or Disable Alarm Severity Filtering - Cisco ONS 15454 Series Procedure Manual

NTP-A168 Enable, Modify, or Disable Alarm Severity Filtering
NTP-A168 Enable, Modify, or Disable Alarm Severity Filtering
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
severity filtering. If you are already logged in, continue with
Step 2 As necessary, complete the
alarm filtering at the card, node, and network views for all nodes in the network. Alarm filtering can be
enabled for alarms, conditions, or events.
As necessary, complete the
Step 3
task on page 22-16
conditions.
As necessary, complete the
Step 4
profile filtering for all network nodes.
Stop. You have completed this procedure.
NTP-A72 Suppress Alarms or Discontinue Alarm Suppression
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step
Complete the
Step 2
autonomous messages that clear specific raised alarms and cause suppressed alarms to appear in the
Conditions window.
Cisco ONS 15454 Procedure Guide, R5.0
7-8
Use this procedure to start, change, or stop alarm filtering for one or more
severities in the Alarms, Conditions, and History windows in all network
nodes.
None
As needed
Onsite or remote
Retrieve or higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A225 Enable Alarm Filtering" task on page
"DLP-A521 Modify Alarm, Condition, and History Filtering Parameters"
to modify the alarm filtering for network nodes to show or hide particular alarms or
"DLP-A227 Disable Alarm Filtering" task on page 19-17
Use this procedure to prevent alarms from being reported for a port, card,
or node in circumstances when an alarm or condition is known to exist but
you do not want to include it in the display. This procedure also provides a
link to a task that explains how to resume normal alarm reporting by
discontinuing the suppression.
None
None
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page
2.
"DLP-A522 Suppress Alarm Reporting" task on page 22-17
Chapter 7
at the node where you want to enable alarm
Step 2.
19-17. This task enables
17-66. If you are already logged in, continue with
to enable the node to send
Manage Alarms
to disable alarm
December 2004