Dlp- A74 Create A New User On A Single Node - Cisco ONS 15454 Series Procedure Manual

DLP-A74 Create a New User on a Single Node
Figure 17-34
Step 5 From the Available Ports list, choose the port that will be protected by the port you selected in the
Protect Port field. Click the top arrow button to move each port to the Working Ports list.
Step 6 Complete the remaining fields:
•
•
•
Click OK.
Step 7
Return to your originating procedure (NTP).
Step 8
DLP-A74 Create a New User on a Single Node
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Security > Users tabs.
Step 1
In the Users window, click Create.
Step 2
In the Create User dialog box, enter the following:
Step 3
Cisco ONS 15454 Procedure Guide, R5.0
17-82
Creating a 1+1 Protection Group
Bidirectional switching—Check this check box if you want both Tx and Rx signals to switch to the
protect port when a failure occurs to one signal. Leave unchecked if you want only the failed signal
to switch to the protect port.
Revertive—Check this check box if you want traffic to revert to the working card after failure
conditions remain corrected for the amount of time entered in the Reversion Time field.
Reversion time—If Revertive is checked, choose a reversion time from the drop-down list. The
range is 0.5 to 12.0 minutes. The default is 5.0 minutes. Reversion time is the amount of time that
will elapse before the traffic reverts to the working card after conditions causing the switch are
cleared. The reversion timer starts after conditions causing the switch are cleared.
This task creates a new user for one ONS 15454.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Superuser
Chapter 17 DLPs A1 to A99
March 2005