Dlp- A206 Clean The Fiber Adapters - Cisco ONS 15454 Series Procedure Manual

Chapter 19 DLPs A200 to A299
Note
Return to your originating procedure (NTP).
Step 6
DLP-A206 Clean the Fiber Adapters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Remove the dust plug from the fiber adapter.
Step 1
Insert a CLETOP stick swab (14100400) into the adapter opening and rotate the swab.
Step 2
Place dust plugs on the fiber adapters when not in use.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-A207 Install Fiber-Optic Cables on the LGX Interface
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Align the keyed ridge of the cable connector with the receiving SC connector on the LGX faceplate
Step 1
connection point. Each module supports at least one transmit and one receive connector to create an
optical carrier port.
Gently insert the cable connector into the faceplate connection point until the connector snaps into place.
Step 2
Connect the fiber optic cable to the OC-N card.
Step 3
September 2005
If you must replace a dust cap on a connector, first verify that the dust cap is clean. To clean the
dust cap, wipe the outside of the cap using a dry, lint-free wipe and the inside of the dust cap
using a CLETOP stick swab (14100400).
This task cleans the fiber adapters.
CLETOP stick swab
None
Required
Onsite
None
This task installs fiber-optic cables on the Lightguide Cross Connect (LGX)
interface in the central office.
Fiber-optic cables
NTP-A112 Clean Fiber Connectors, page 15-13
As needed
Onsite
None
DLP-A206 Clean the Fiber Adapters
Figure 19-1 shows the cable location.
Cisco ONS 15454 Procedure Guide, R5.0
19-5