Cisco ONS 15454 Series Procedure Manual page 143

Chapter 5 Turn Up Network
b.
c.
Click the Conditions tab.
Step 24
a.
b.
If a node fails any test, repeat the test while verifying correct setup and configuration. If the test fails
Step 25
again, refer to the next level of support.
After all tests are successfully completed and no alarms exist in the network, the network is ready for
service application. Continue with
Stop. You have completed this procedure.
NTP-A178 Provision a Traditional BLSR Dual-Ring Interconnect
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To route circuits on the DRI, you must check the Dual Ring Interconnect check box during circuit
Note
creation.
Complete the
Step 1
Step 2.
Complete the following steps if you have not provisioned the BLSRs that you will interconnect in a
Step 2
BLSR DRI. If the BLSRs are created, go to Step 3.
a.
b.
c.
d.
December 2004
Verify that no unexplained alarms appear. If unexplained alarms appear, resolve them before
continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
Complete the "DLP-A516 Export CTC Data" task on page 22-6
Verify that no unexplained conditions appear. If unexplained conditions appear, resolve them before
continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
Complete the "DLP-A516 Export CTC Data" task on page 22-6
information.
This procedure provisions BLSRs in a traditional dual-ring interconnect
(DRI) topology. DRIs interconnect two or more BLSRs to provide an
additional level of protection. Two-fiber and four-fiber BLSRs can be
mixed in a traditional BLSR DRI network.
None
NTP-A35 Verify Node Turn-Up, page 5-2
As needed
Onsite
Provisioning and higher
"DLP-A60 Log into CTC" task on page
Complete the "NTP-A40 Provision BLSR Nodes" procedure on page 5-10
Complete the "NTP-A126 Create a BLSR" procedure on page 5-12
Complete the "NTP-A175 Two-Fiber BLSR Acceptance Test" procedure on page 5-13
two-fiber BLSRs.
Complete the "NTP-A176 Four-Fiber BLSR Acceptance Test" procedure on page 5-15
four-fiber BLSRs.
NTP-A178 Provision a Traditional BLSR Dual-Ring Interconnect
Chapter 6, "Create Circuits and VT Tunnels."
17-66. If you are already logged in, continue with
Cisco ONS 15454 Procedure Guide, R5.0
to export the alarm information.
to export the conditions
to provision the BLSRs.
to create the BLSRs.
to test
to test
5-17