Dlp- A310 View Ethernet Trunk Utilization - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
DLP-A310 View Ethernet Trunk Utilization
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance > Ether Bridge > Trunk Utilization tabs.
Step 1
Step 2 Select the desired time interval in the Interval field.
Click Refresh.
Step 3
The trunk utilization information for the current and previous time intervals is displayed.
Return to your originating procedure (NTP).
Step 4
DLP-A311 Provision a Half Circuit Source and Destination on a BLSR or 1+1
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Node drop-down list, choose the node that will contain the half circuit.
Step 1
Step 2 From the Slot drop-down list, choose the slot containing the card where the circuit will originate.
Step 3 From the Port drop-down list, choose the port where the circuit will originate. This field is not available
if a DS-1 card is chosen in
Step 4 If the circuit is a DS-1 circuit and you choose a DS-1 card as the source, choose the DS-1 where the
traffic will originate from the DS1 drop-down list.
Step 5 Click Next.
Step 6 From the Node drop-down list, choose the node chosen in
From the Slot drop-down list, choose the OC-N card that you will use to map the DS-1 to a VT1.5 for
Step 7
OC-N transport or to map the DS-3 or OC-N synchronous transport signal (STS) circuit to an STS.
March 2005
This task displays the Ethernet Trunk bandwidth usage on any node with
one or more E-Series Ethernet cards installed.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
This task provisions a half circuit source and destination for BLSR and 1+1
configurations. A half circuit allows you to provision a partial path (one
end of a circuit), for example, if you want to provision a circuit with the
intent that the path will be completed at a later time or at a different
location.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Step 2.
DLP-A310 View Ethernet Trunk Utilization
Step 1.
Cisco ONS 15454 Procedure Guide, R5.0
20-5