Figure 17-8 Installing The Amp Champ Eia - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
Align the AMP Champ panel with the backplane and insert and tighten the nine perimeter screws
Step 1
(P/N 48-0358) at 8 to 10 lb (3.6 to 4.5 kg).
Align an AMP Champ card with the backplane connector and push until it fits snugly. Repeat until you
Step 2
have installed all six AMP Champ cards.
To secure each AMP Champ card to the cover panel, insert and tighten a screw (P/N 48-0003) at the top
Step 3
of each card at 8 to 10 lb (3.6 to 4.5 kg).
Place the AMP Champ fastening plate along the bottom of the cover panel, and hand-tighten the two
Step 4
thumbscrews.
Figure 17-8
Figure 17-8
Return to your originating procedure (NTP).
Step 5
March 2005
shows an AMP Champ EIA installation.
Installing the AMP Champ EIA
DLP-A14 Install the AMP Champ EIA
Cisco ONS 15454 Procedure Guide, R5.0
17-17