Dlp- A198 Clear A Path Protection Force Switch - Cisco ONS 15454 Series Procedure Manual

DLP-A198 Clear a Path Protection Force Switch
DLP-A198 Clear a Path Protection Force Switch
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu at the node view, choose Go to Network View.
Step 1
Right-click the span where you want to clear the switch. Choose Circuits from the shortcut menu.
Step 2
In the Circuits on Span dialog box, choose CLEAR to remove the Force switch. Click Apply.
Step 3
In the Confirm UPSR Switch dialog box, click Yes.
Step 4
In the Protection Switch Result dialog box, click OK.
Step 5
In the Circuits on Span window, the Switch State for all path protection circuits is CLEAR.
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15454 Procedure Guide, R5.0
18-70
This task clears a path protection Force switch.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Maintenance or higher
Chapter 18 DLPs A100 to A199
March 2007