Table 3-1 Ctc Computer Setup For Local Craft Connections To The Ons 15454; Figure - Cisco ONS 15454 Series Procedure Manual

Chapter 3 Connect the PC and Log into the GUI
Complete one of the CTC computer setup tasks shown in
Step 1
environment.
Table 3-1
CTC Connection Environment
You are connecting from a Windows PC.
•
All nodes that you will access run software earlier
•
than Release 3.3.
You will connect to one ONS 15454.
•
You need to access non-ONS 15454 applications
•
such as ping and tracert (trace route).
You are connecting from a Windows PC.
•
• The CTC computer is provisioned for Dynamic
Host Configuration Protocol (DHCP).
The ONS 15454 has DHCP forwarding enabled.
•
• The ONS 15454 is connected to a DHCP server.
Note
• You are connecting from a Windows PC.
• All nodes that you will access run software
Release 3.3 or later.
You will connect to ONS 15454s at different
•
locations and times and do not wish to reconfigure
your PC's IP settings each time.
• You will not access or use non-ONS 15454
applications such as ping and tracert (trace route).
• You will connect to the ONS 15454 TCC2 Ethernet
port or backplane LAN pins either directly or
through a hub.
• You are connecting from a Solaris workstation.
• You will connect to one ONS 15454.
You need to access non-ONS 15454 applications
•
such as ping and traceroute.
Connect a straight-through (CAT-5) LAN cable from the PC or Solaris workstation NIC to one of the
Step 2
following:
RJ-45 (LAN) port on the active or standby TCC2/TCC2P card
•
RJ-45 (LAN) port on a hub or switch to which the ONS 15454 is physically connected
•
December 2004
CTC Computer Setup for Local Craft Connections to the ONS 15454
The ONS 15454 does not provide IP addresses.
If DHCP is enabled, it passes DCHP requests to
an external DHCP server.
NTP-A234 Set Up CTC Computer for Local Craft Connection to the ONS 15454
Table 3-1
CTC Computer Setup Task
DLP-A50 Set Up a Windows PC for Craft
Connection to an ONS 15454 on the Same
Subnet Using Static IP Addresses, page 17-56
DLP-A51 Set Up a Windows PC for Craft
Connection to an ONS 15454 Using Dynamic
Host Configuration Protocol, page 17-58
Do not use this task for initial node
Note
turn-up. Use the task only if DHCP
forwarding is enabled on the
ONS 15454. By default, DHCP is not
enabled. To enable it, see the
"NTP-A169 Set Up CTC Network
Access" procedure on page
DLP-A52 Set Up a Windows PC for Craft
Connection to an ONS 15454 Using
Automatic Host Detection, page 17-61
DLP-A53 Set Up a Solaris Workstation for a
Craft Connection to an ONS 15454, page
17-63
Cisco ONS 15454 Procedure Guide, R5.0
based your CTC connection
4-7.
3-3