Ntp- A4 Remove The Backplane Covers - Cisco ONS 15454 Series Procedure Manual

Chapter 1 Install the Shelf and Backplane Cable
NTP-A4 Remove the Backplane Covers
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed.
Complete the
Step 1
Step 2 Complete the
Step 3 If you plan to install electrical interface assemblies (EIAs), continue with the
procedure on page
page
Stop. You have completed this procedure.
NTP-A5 Install the EIAs
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
March 2005
This procedure describes how to access the backplane by removing the
covers. The backplane has two sheet metal covers (one on either side)
and a lower backplane cover at the bottom.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-A2 Install the Shelf Assembly, page 1-5
NTP-A3 Open and Remove the Front Door, page 1-6
Required
Onsite
None
"DLP-A10 Remove the Lower Backplane Cover" task on page
"DLP-A11 Remove the Backplane Sheet Metal Cover" task on page
1-7. If not, continue with the
1-9.
This procedure describes how to install electrical interface assemblies
(EIAs). Typically, an EIA panel is installed on the backplane during
manufacturing, but EIA panels can be ordered separately. Refer to the
Cisco ONS 15454 Reference Manual for descriptions of the EIAs.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Perimeter screws (9)
Inner screws (12)
Backplane cover screws (5)
EIA card (SMB, BNC, AMP Champ, UBIC-V, UBIC-H, MiniBNC)
NTP-A4 Remove the Backplane Covers, page 1-7
Required if the node will use electrical signals
NTP-A4 Remove the Backplane Covers
"NTP-A6 Install the Power and Ground" procedure on
Cisco ONS 15454 Procedure Guide, R5.0
17-10.
17-11.
"NTP-A5 Install the EIAs"
1-7