Cisco ONS 15454 Series Procedure Manual page 231

Chapter 6 Create Circuits and VT Tunnels
•
•
•
Click OK.
c.
Tip
In the Available VLANs column, click the VLAN you want to use and click the arrow button (>>) to
Step 17
move the VLAN to the Circuit VLANs column.
Note
Click Next.
Step 18
In the Circuit Routing Preferences area, uncheck the Route Automatically check box and click Next.
Step 19
In the Route Review and Edit area, click the source node, then click a span (green arrow) leading away
Step 20
from the source node.
The span turns white.
Click Add Span.
Step 21
The span turns blue. CTC adds the span to the Included Spans list.
Step 22 Click the node at the end of the blue span.
Step 23 Click the green span joining the node selected in
The span turns white.
Click Add Span.
Step 24
The span turns blue.
Repeat Steps
Step 25
In the Route Review and Edit area, verify that the new circuit is correctly configured. If the circuit
Step 26
information is not correct, click the Back button and repeat Steps
information.
Note
Click Finish.
Step 27
Complete the
Step 28
carries the circuit.
Complete the
Step 29
page 19-14
Complete the
Step 30
August 2005
VLAN Name—Assign an easily identifiable name to your VLAN.
VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15454 network supports
a maximum of 509 user-provisionable VLANs.
Topology Host—Choose the topology host ID from the drop-down list.
You can also add VLANs in network view by choosing Tools > Manage VLANs. In the All
VLANs dialog box, click the Create button to open the Define New VLAN dialog box.
Moving the VLAN from Available VLANs to Circuit VLANs forces all the VLAN traffic to use
the shared packet ring you are creating.
21 through 24 for every node in the ring.
If the circuit is incorrect, you can also click Finish, delete the completed circuit, and begin the
procedure again.
"DLP-A220 Provision E-Series Ethernet Ports" task on page 19-13
"DLP-A221 Provision E-Series Ethernet Ports for VLAN Membership" task on
for each node that carries the circuit.
"NTP-A146 Test E-Series Circuits" procedure on page
NTP-A142 Create an E-Series Shared Packet Ring Ethernet Circuit
Step 22.
7 through
6-72.
Cisco ONS 15454 Procedure Guide, R5.0
25 with the correct
for each node that
6-63