Cisco ONS 15454 Series Procedure Manual page 388

NTP-A223 View the ONS 15454 Timing Report
Table 15-2 ONS 15454 Timing Report (continued)
Item Description
Status
(cont.)
Status Date and time of
Changed the last status
At change.
Switch Type of switch.
Type
Reference Indicates the
timing
reference.
Selected Indicates
whether the
reference is
selected.
Facility Indicates the
timing facility
provisioned for
the reference on
the
Provisioning >
Timing tab.
State Indicates the
timing reference
state.
Condition Indicates the
timing reference
state.
Condition Indicates the
Changed date and time of
the last status
change in
MM/DD/YY
HH:MM:SS
format.
SSM Indicates
whether SSM is
enabled for the
timing
reference.
Cisco ONS 15454 Procedure Guide, R5.0
15-20
Option
FAST_START_FAILED_STATE
—
AUTOMATIC
Manual
Force
Three timing references (Ref-1,
Ref-2, and Ref-3) are available on
the Provisioning > Timing tab.
Selected references are indicated
with an X.
BITS-1
BITS-2
OC-N card with port #
Internal clock
IS
OOS
OKAY
OOB
—
Enabled
Disabled
Option Description
A timing reference is too far away to reach in normal
state. The fast start state could not acquire sufficient
timing information within the allowable amount of time.
—
The timing switch was system-generated.
The timing switch was a user-initiated Manual switch.
The timing switch was user-initiated Force switch.
These options indicate the timing references that the
system uses, and the order in which they are called. (For
example, if Ref-1 becomes available, Ref-2 is called.)
—
The timing facility is a building integrated timing supply
(BITS) clock attached to the node's BITS-1 pins.
The timing facility is a BITS clock attached to the node's
BITS-2 pins.
If the node is set to line timing, this is the OC-N card and
port provisioned as the timing reference.
The node is using its internal clock.
The timing reference is in service.
The timing reference is out of service.
The reference is valid to use as a timing reference.
Out of bounds; the reference is not valid and cannot be
used as a timing reference, for example, a BITS clock is
disconnected.
—
SSM is enabled.
SSM is not enabled.
Chapter 15 Maintain the Node
December 2004