Dlp- A356 Tcc2/Tcc2P Card Active/Standby Switch Test - Cisco ONS 15454 Series Procedure Manual

DLP-A356 TCC2/TCC2P Card Active/Standby Switch Test
Click the Performance tab.
Step 2
Click the Utilization or the History tab.
Step 3
From the Interval drop-down list, choose one of four options:
Step 4
•
•
•
•
Click Refresh. The PM counts refresh with values based on the selected time interval.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-A356 TCC2/TCC2P Card Active/Standby Switch Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 From the View menu, choose Go to Network View.
Click the Alarms tab.
Step 2
a.
b.
Click the Conditions tab. Verify that no unexplained conditions appear on the network. If unexplained
Step 3
conditions appear, resolve them before continuing. Refer to the Cisco ONS 15454 Troubleshooting
Guide if necessary.
Step 4 On the network map, double-click the node containing the TCC2/TCC2P cards that you are testing to
open it in node view.
Step 5 Examine the LEDs on the shelf graphic a nd note which TCC2/TCC2P card is active and which is
standby. TCC2/TCC2P cards are installed in Slot 7 and Slot 11. The active TCC2/TCC2P card has a
green ACT LED, and the standby TCC2/TCC2P card has an amber SBY LED.
On the shelf graphic, right-click the active TCC2/TCC2P card and choose Reset from the shortcut menu.
Step 6
Step 7 In the Resetting Card dialog box, click Yes. After 20 to 40 seconds, a "lost node connection, changing
to network view" message appears. On the network view map, the node where you reset the
TCC2/TCC2P card will be gray.
Cisco ONS 15454 Procedure Guide, R5.0
20-40
1 min: This option appears the specified PM counts in one-minute time intervals.
15 min: This option appears the specified PM counts in 15-minute time intervals.
1 hour: This option appears the specified PM counts in one-hour time intervals.
1 day: This option appears the specified PM counts in one-day (24 hours) time intervals.
This task verifies that the TCC2/TCC2P cards can effectively switch from
one to another.
The test set specified by the acceptance test procedure, connected and
configured as specified in the acceptance test procedure.
DLP-A60 Log into CTC, page 17-66
Required
Onsite
Provisioning or higher
Verify that the alarm filter is not on. See the
page 19-17 as necessary.
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
"DLP-A227 Disable Alarm Filtering" task on
Chapter 20 DLPs A300 to A399
March 2005