Dlp- A99 Determine Available Vlans - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
DLP-A99 Determine Available VLANs
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In any CTC view, click the Circuits tab.
Step 1
Click any existing Ethernet circuit.
Step 2
Step 3 Click Edit, then click the VLANs tab.
The Edit Circuit dialog box shows the number of VLANs used by circuits and the total number of
VLANs available for use.
Step 4 Determine that the number of available VLANs listed is sufficient for the number of E-Series Ethernet
circuits that you will create.
Multiple E-Series Ethernet circuits with spanning tree enabled block each other if the circuits traverse
Caution
the same E-Series Ethernet card and use the same VLAN.
Return to the originating procedure (NTP).
Step 5
March 2005
This task verifies that the network has the capacity to support the additional
new VLANs required for the creation E-Series circuits. It does not apply
to E-Series cards in port-mapped mode.
E-Series Ethernet cards (E100T-12/E100T-G, E1000-2/E1000-2-G) must
be installed at each end of the Ethernet circuit.
NTP-A127 Verify Network Turn Up, page 6-4
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
DLP-A99 Determine Available VLANs
Cisco ONS 15454 Procedure Guide, R5.0
17-99